全文获取类型
收费全文 | 31256篇 |
免费 | 2975篇 |
国内免费 | 1448篇 |
专业分类
电工技术 | 9049篇 |
综合类 | 2879篇 |
化学工业 | 1523篇 |
金属工艺 | 835篇 |
机械仪表 | 1927篇 |
建筑科学 | 1540篇 |
矿业工程 | 1482篇 |
能源动力 | 1041篇 |
轻工业 | 523篇 |
水利工程 | 853篇 |
石油天然气 | 1243篇 |
武器工业 | 238篇 |
无线电 | 6839篇 |
一般工业技术 | 1056篇 |
冶金工业 | 934篇 |
原子能技术 | 662篇 |
自动化技术 | 3055篇 |
出版年
2024年 | 60篇 |
2023年 | 278篇 |
2022年 | 508篇 |
2021年 | 695篇 |
2020年 | 758篇 |
2019年 | 553篇 |
2018年 | 511篇 |
2017年 | 804篇 |
2016年 | 969篇 |
2015年 | 1103篇 |
2014年 | 2066篇 |
2013年 | 1615篇 |
2012年 | 2360篇 |
2011年 | 2556篇 |
2010年 | 1938篇 |
2009年 | 1944篇 |
2008年 | 1902篇 |
2007年 | 2342篇 |
2006年 | 2120篇 |
2005年 | 1733篇 |
2004年 | 1546篇 |
2003年 | 1333篇 |
2002年 | 1128篇 |
2001年 | 940篇 |
2000年 | 806篇 |
1999年 | 595篇 |
1998年 | 428篇 |
1997年 | 378篇 |
1996年 | 340篇 |
1995年 | 293篇 |
1994年 | 272篇 |
1993年 | 179篇 |
1992年 | 147篇 |
1991年 | 114篇 |
1990年 | 90篇 |
1989年 | 88篇 |
1988年 | 71篇 |
1987年 | 30篇 |
1986年 | 18篇 |
1985年 | 14篇 |
1984年 | 17篇 |
1983年 | 7篇 |
1982年 | 7篇 |
1981年 | 4篇 |
1980年 | 3篇 |
1979年 | 4篇 |
1975年 | 1篇 |
1959年 | 4篇 |
1956年 | 1篇 |
1951年 | 3篇 |
排序方式: 共有10000条查询结果,搜索用时 553 毫秒
1.
2.
基于传统易碎薄板机械手位置伺服控制系统稳定性低、自动化分拣效率低等不足,设计了一种基于笛卡尔坐标式的气动码垛机器手和位置伺服稳定性控制系统。首先,设计并介绍笛卡尔坐标式码垛机械手的基本组成结构,对机械手末端吸盘气动回路控制系统进行设计和分析;然后分别对机械手X、Y、Z三个方向的伺服电机控制原理进行分析并设计了一种位置伺服系统的前馈自适应控制算法;最后,将传统位置闭环PID算法和前馈自适应控制算法进行位置跟踪稳定性对比试验。实验结果表明该笛卡尔坐标式的气动码垛机器手和位置伺服稳定性控制系统设计合理,满足实际生产要求。 相似文献
3.
采用去离子水作为实验工质,在低压低流速自然循环工况下开展了单面加热可视化窄矩形通道内的过冷沸腾摩擦阻力特性实验研究。实验中测量了实验段内的压降数据,并通过高速摄影仪拍摄了窄矩形通道内的气液两相图像,提出了过冷沸腾条件下的两相摩擦压降的剥离计算方法。基于本实验中获得摩擦压降数据,对分别基于均相流模型和分液相模型的经典两相摩擦压降计算关系式进行了评估,实验结果表明:采用不同等效黏度计算方法的均相流模型计算结果比实验值明显偏小;而分相流模型中,Sun and Mishiba关系式和Tran关系式均能够较好地预测摩擦阻力,计算值与实验值的平均相对偏差在±15%以内。结合实验数据,以分相流模型方法为基础,考虑全液相Reynolds数、Martinelli参数和Laplace数的影响,获得了计算分液相折算系数的经验关系式,与实验数据符合较好, 平均相对误差在10%范围内。 相似文献
4.
针对传统低压回路电阻测试仪只能在被测设备停电时使用的一大限制,本文提出并设计了一种新型低压回路电阻测试仪。该仪器可在低压设备运行状态下对其回路电阻进行测量,在保证测量精度的前提下减少了设备停电率,大大提高了工作效率。 相似文献
5.
This study proposes that a novel integrated circuit (IC) and system design for renewable energy inverters can harvest renewable energy to power direct current (DC) and alternating current (AC) loads. In addition, an intelligent synthesis and management tool is developed to design the proposed system and to judge the system’s operational maintenance decisions. Finally, a renewable energy inverter’s information is posted to an online system. Users can obtain the proposed system’s information at any time and place. The accurate and superior performance of the proposed IC and system is confirmed by computer simulations and experimental results. 相似文献
6.
海洋核动力平台因其突出的安全性已成为当今核能领域热点研究问题之一,但在海洋等非惯性条件下会使一回路系统的热工特性发生变化。针对此问题,本文对几种典型的一回路系统在摇摆条件下的自然循环流量波动特性进行计算分析。分别建立典型的双环路、三环路、四环路的一回路系统模型布置方案,并同时考虑摇摆中心的位置,根据流体动量守恒方程,得到不同状态下一回路系统内的流量变化规律。对于单堆双环路系统,摇摆中心在船上/中/下部位置时,环路流量波动幅度分别为13.2%/11.2%/9.5%,堆芯流量波动幅度分别为0.9%/0.8%/0.6%;对于单堆三环路系统,摇摆中心在船下部时,环路流量和堆芯流量波动幅度分别为9.2%和0.8%;对于单堆四环路系统,摇摆中心在船下部时,布置方案1和方案2的环路流量波动幅度分别为9.5%和9.2%,堆芯流量波动幅度分别为0.9%和0.7%。计算结果表明:采用单堆双环路的设计布置方案是最有利于系统稳定性的。 相似文献
7.
8.
本文结合HTH电路的复杂性等特征分析与实际应用现状,研究了HTH电路的具体检测技术方法并对当前热点技术进行对比分析,探讨了HTH电路检测方法的技术发展趋势。 相似文献
9.
An alternative Equivalent Electrical Circuit for Proton Exchange Membrane Fuel Cells is modelled in this study. Both I–V characteristics and H2 consumptions corresponding to generated power under load and no-load conditions are investigated. For this purpose, H2 consumptions and I–V characteristics of three different sized PEMFCs are tested. There is a very good harmony between the model results and measured values (relative error %0.7, %6.4 and %2.5 for FC-A, FC-B and FC-C respectively). In the proposed model current passes only on parallel resistance and not on serial resistance at no-load condition. Thus, a FC with higher parallel resistance should be preferred. Another key output of this study is that based on the proposed model, performance comparison of FCs can be performed with the parameters defined in this work. Proposals made in this study can easily be used for performance analysis of FCs under for both steady state and transient analysis. 相似文献
10.
The 3D structure electromagnetic computation presents several difficulties related to the volume mesh. In fact, the entire volume space must be taken into account even the smallest details. In this article, we propose a formulation based on the reciprocity theorem combined with the generalized equivalent circuit method to model a planar 3D structure with both coaxial and planar excitation. The major advantage of this formulation is the fact to reduce the computational volume into 2D ones in the discontinuity plane. In addition, we focused on the calculation of the discontinuity between the excitation source and the planar structure to determine the exact behavior of the electric coaxial excitation model. The obtained current density, electric field distributions, and the input impedance are presented and discussed in the following sections. An approximately good agreement of input impedance with those obtained by the simulator and measurement is shown. 相似文献